. .
  1. #1
    Does anybody have ANY information about the Sirel / MAC F9306B spindle driver pinout?
    I considered using my MAC driver (same as Sirel F9306B) for a while before i decided for a replacement driver motor combination With my CSMIO/TP-S Controller.
    I know how it was Connected to the old processor unit, but not quite sure if it will be compatible With the CSMIO Controller.
    Haven`t got the foggiest idea about the pinout definitions on the old Mac Controller, but here is a draft of how it was set up previously.
    Output to motor(Parker RS520GR1000) is 20.7 to 107VDC.
    I have not idea about the meaning of abbreviations CB-B, VAL, -DOK, +DOK or VB(second channel B?).
    I do however believe 0 to be 0V in association with +12V and -12V... in think..



    Click image for larger version. 

Name:	Sirel_Connection.jpg 
Views:	248 
Size:	77.1 KB 
ID:	19488


    Any good ideas or tips?

    Regards


    Last edited by Proteus; 25-10-2016 at 08:11 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Boxford VMC 300 Sirel Spindle Drive and motor
    By Joe in forum Boxford Vertical Mills
    Replies: 0
    Last Post: 12-08-2015, 07:46 PM
  2. Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  3. New SCR driver board, or new motor & VFD?
    By m_c in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 04-11-2010, 05:16 PM
  4. Motor & Driver setup
    By action-kat in forum General Electronics
    Replies: 8
    Last Post: 19-07-2010, 11:24 AM
  5. Stepper Motor Driver v2.3 2A $20 !!!
    By Lee Roberts in forum Motor Drivers & Controllers
    Replies: 15
    Last Post: 17-05-2009, 10:57 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •