1. #1
    I would welcome an opinion on the Kay software used for feeding Isel control boxes with remote code. Can it be used independently of the Galaad software for instance. Indeed if you are using an original Isel box I would be most grateful for any communication and advice ref. addons. Tool Z height pads etc.

  2. #2
    LGM's Avatar
    Lives in Lugdunum, France. Last Activity: 6 Days Ago Has been a member for 0-1 years. Has a total post count of 9.
    Hi Leadhead,

    As a new user, I just discover this one year old post.

    Do you still need information?

  3. #3
    Thank you no. I have changed the complete system to PlanetCNC.

  4. #4
    LGM's Avatar
    Lives in Lugdunum, France. Last Activity: 6 Days Ago Has been a member for 0-1 years. Has a total post count of 9.
    You're welcome.

    Are you satisfied of Planet CNC products? Which one did you choose? Is it reliable and user-friendly?

    I am also considering switching from Isel electronics to another system. I eliminated Mach and I am having a look at UCCNC and Planet CNC products.

    Did you compare them before choosing Planet CNC?

    Thanks in advance.

  5. #5
    I am reasonably happy with PlanetCNC. It was a close call between that and UCCNC. I am just a little concerned with the development rate of the TNG software and the lack of a pdf manual. But as far as it goes, very good.

  6. The Following User Says Thank You to Leadhead For This Useful Post:

    LGM

  7. #6
    LGM's Avatar
    Lives in Lugdunum, France. Last Activity: 6 Days Ago Has been a member for 0-1 years. Has a total post count of 9.
    OK, thank you!

  8. #7
    I do have a licenced copy of the Kay software for sale if it is of any interest.

Similar Threads

  1. software
    By rainboweyes in forum Computer Software
    Replies: 4
    Last Post: 09-02-2013, 11:59 AM
  2. Replies: 2
    Last Post: 11-12-2012, 12:58 PM
  3. Galaad & Dongle
    By Brownhills school in forum General Discussion
    Replies: 0
    Last Post: 14-07-2011, 08:32 PM
  4. Galaad dongle needed
    By Brownhills school in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 09-07-2011, 12:01 AM
  5. Which Software
    By Ricardoco in forum CAD & CAM Software
    Replies: 41
    Last Post: 12-01-2011, 04:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •