. .
  1. #1
    Hi,

    I've recently acquired a system with a DIYCNC C4 controller (with just the 3 axes) and wanted to add a spindle controller.
    And I've just noticed (and as referenced in other threads) that the company is now defunct.
    Can anyone advise what my best course of action is? I'm not averse to making custom bits + bobs btw..
    If it makes a difference my spindle is a Kress FM6955
    Many thanks in advance
    Pat

  2. #2
    The old Spindle 4 board will start a spindle and supply 0 - 10v volts [ on a good day ] for speed control but the kress can't handle that for speed control, however it will switch a spindle off and on via a rely.

    Checked today and I do have one left.
    John S -

  3. #3
    Thanks for the reply John.
    How would I go about relieving you of that? :)
    (I can see I could do with a better spindle but would still need the board)
    Pat

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. [HELP] 6 Axis B.O.B with spindle control
    By birchy in forum General Discussion
    Replies: 7
    Last Post: 02-10-2014, 12:15 AM
  2. EMCO Spindle Control
    By Pete92 in forum Spindles & Drive Motors
    Replies: 1
    Last Post: 06-11-2013, 10:20 PM
  3. Spindle Speed Control
    By cncJim in forum Spindles & Drive Motors
    Replies: 15
    Last Post: 18-06-2013, 07:53 PM
  4. Help with spindle control
    By wizzy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 12-02-2011, 12:51 AM
  5. CNC spindle control VFD problem
    By djc in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 13-09-2009, 09:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •