Thread: VMC300 Toolholder question
Threaded View
-
19-12-2016 #10
Last Activity: 07-04-2017
Still looking around :-x
Measured the angle and although it might not be dead accurate, it reads 21 degrees.
(Se Attached sketch)
I just hope Coventry feedback next week will tell me something...
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Boxford VMC300 conversion & parts. Help really needed.
By Proteus in forum Boxford Vertical MillsReplies: 0Last Post: 13-09-2016, 02:13 PM -
How to remove coventry easychange chuck/toolholder
By Rabs in forum Milling Machines, Builds & ConversionsReplies: 5Last Post: 06-11-2015, 07:08 PM -
To usb,or not to usb,that is the question.
By Jumbo in forum General DiscussionReplies: 11Last Post: 17-10-2011, 09:21 PM -
question ...
By Wobblybootie in forum General DiscussionReplies: 6Last Post: 04-01-2010, 12:04 AM -
A question
By bodgeitandscarper in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 02-12-2009, 08:30 AM
Bookmarks