Desktop type router - Fixed gantry - steel frame MK2

[Tom J]

Looks good, I'd beef up the bed as it looks weak compared to the rest of your machine ��

Sent from my HUAWEI VNS-L31 using Tapatalk

Added T6 20mm plate:)

[Robin Hewitt]

Robin think you better explain because even I can't tell where your coming from with this statement.? If your meaning what I think where is going to put the ballscrew.?

I can't explain, I should probably shut up, it just looks unfinished. If the router moved back towards the gantry it would look better. If the lower Z axis bearings were at the bottom of the gantry it would look better. If the bed bearings were under the gantry so it didn't depend on verticals screwed to horizontals I would be rubbing my hands together in glee and shouting whoopy do!

[Tom J]

Robin do appreciate your comments, so far I managed to skim 10mm by putting spindle closer to the plate.
Problem is that I should ask first and fabricate later. I am seating on it now - previous correction was easier to do.
I will put X axis bearing on top and bottom of the gantry - saving a lot of distance but sacrifice stiffens (extra 50mm taller legs)
Regard the bed bearings as you see from current design they are in between spindle center point - so perfect position (this will moved towards gantry later).

[Tom J]

now Z rails left - this will complicate fabrication, thinking now to use alloy plate and make kind of box design

[Tom J]

some modification made to design - thanks Rob
in:)



I managed to short less than 50mm in overhang - hope will be worth it.