. .

Thread: UC300 Ethernet

Page 2 of 2 FirstFirst 12
  1. #11
    Ah yes of course there are the multipliers...

  2. #12
    Still there is some margin there!

  3. #13
    Yes, generally, 100Khz is more than enough for stepper motors.
    Gerry
    ______________________________________________
    UCCNC 2022 Screenset

    Mach3 2010 Screenset

    JointCAM - CAM for Woodworking Joints

  4. The Following User Says Thank You to Ger21 For This Useful Post:


Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Uc300 motion controller problems
    By Hellfire in forum CNCdrive (UCCNC)
    Replies: 2
    Last Post: 07-11-2016, 07:21 PM
  2. Help mach3 ethernet set up
    By kell in forum Artsoft Mach (3 & 4)
    Replies: 3
    Last Post: 06-12-2015, 10:26 PM
  3. Grounding help, UCCNC, UC300 and connection loss
    By gabi68 in forum CNCdrive (UC100, UC300ETH)
    Replies: 6
    Last Post: 14-10-2015, 07:42 PM
  4. FOR SALE: uc300 motion control board slighly used
    By dazza in forum Items For Sale
    Replies: 1
    Last Post: 09-09-2015, 12:25 PM
  5. FOR SALE: uc300 motion control board slighly used
    By dazza in forum Items For Sale
    Replies: 0
    Last Post: 09-09-2015, 12:23 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •