1. #1
    Hi, I have a HEIDENHAIN VRZ 731B fitted on a Bridgeport Milling M/c. Was all ok but now just blows the 400mA fuse on the back. No lights, nothing. Any ideas? Anyone have a circuit diagram for this?

  2. #2
    Get Heidenhains number off the web and give them a ring.
    I have found them to be most helpful in past circumstances unlike Fanuc who even want a credit card number to talk to you.
    John S -

  3. #3
    I did try them. They say the support stopped 15 yrs ago. Plus no circuit diagrams available. I'm guessing it's a Power Supply issue.

Similar Threads

  1. Wabeco controller fuse blowing
    By Stewart in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 01-03-2015, 10:37 PM
  2. Bridgeport VMC with Heidenhain control-
    By vargai in forum Gantry/Router Machines & Building
    Replies: 3
    Last Post: 13-01-2015, 02:37 PM
  3. So close.....am882 driver blowing fuse
    By Danielroyal25 in forum Motor Drivers & Controllers
    Replies: 12
    Last Post: 29-03-2014, 09:32 PM
  4. 3 axis driver...Fuses keep blowing
    By dudz in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 28-01-2013, 08:05 PM
  5. Heidenhain DRO fault
    By Lancer in forum General Electronics
    Replies: 5
    Last Post: 29-06-2012, 09:57 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts