Page 29 of 29 FirstFirst ... 19272829
  1. Guys, has anyone got any experience or knowledge of these spindles I stumbled across?

    They are 80mm body and 220v/2.2kw/400hz so should be a straight drop in/drop out replacement (ideal as it makes it relatively easy to switch to 24,000rpm spindle if needed for composites etc). The difference is that they are 1,500-12,000rpm which would be a lot more suitable RPM range for milling plastics, foams, metals etc and opens up the potential to look at thread mills, reamers and makes drilling more viable.

    Only downside is they are significantly more expensive than the 24,000rpm garden variety... which makes it less appealing to take a punt!

    https://www.aliexpress.com/item/Low-...460.0.0.rut9B3

  2. The Following User Says Thank You to Zeeflyboy For This Useful Post:


  3. #282
    Quote Originally Posted by Zeeflyboy View Post
    Guys, has anyone got any experience or knowledge of these spindles I stumbled across?

    They are 80mm body and 220v/2.2kw/400hz so should be a straight drop in/drop out replacement (ideal as it makes it relatively easy to switch to 24,000rpm spindle if needed for composites etc). The difference is that they are 1,500-12,000rpm which would be a lot more suitable RPM range for milling plastics, foams, metals etc and opens up the potential to look at thread mills, reamers and makes drilling more viable.

    Only downside is they are significantly more expensive than the 24,000rpm garden variety... which makes it less appealing to take a punt!

    https://www.aliexpress.com/item/Low-...460.0.0.rut9B3
    Good find
    http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm

    If you didn't buy it from China the company you bought it from did ;)

Page 29 of 29 FirstFirst ... 19272829

Similar Threads

  1. Initial design advise wanted
    By driftspin in forum Gantry/Router Machines & Building
    Replies: 45
    Last Post: 24-10-2017, 05:55 PM
  2. Initial Design Check Please
    By Gotty101 in forum Gantry/Router Machines & Building
    Replies: 90
    Last Post: 28-02-2017, 06:53 PM
  3. Critique required on y-axis design.
    By Spedley in forum Gantry/Router Machines & Building
    Replies: 2
    Last Post: 06-05-2013, 08:17 PM
  4. About to build CNC miller, need design critique please
    By JW149 in forum Milling Machines, Builds & Conversions
    Replies: 8
    Last Post: 23-04-2012, 08:28 PM
  5. NEW MEMBER: About to build CNC miller, need design critique please
    By JW149 in forum New Member Introductions
    Replies: 1
    Last Post: 22-04-2012, 06:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •