Thread: Crap chinese router problems
Threaded View
-
13-03-2017 #10
you can control the spindle from nc studio on the pc however as soon as your raise the spindle speed over 10000 that is when it cuts out, it strats back up as soon as you go back down.
I will take a look were the grey cable goes when I'm next at the machine.
If you could tell me what the values should be for each of the program setting that would be great! the setting the chap on cnc zone unfortunately did not help. the spindle is 220v 6A and we are on 240v mains power here in Australia.
many thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
On going chinese 6040 problems
By amxen in forum Chinese MachinesReplies: 65Last Post: 03-06-2020, 08:46 AM -
More Problems with Chinese 6040
By Rye in forum Chinese MachinesReplies: 11Last Post: 07-12-2017, 01:13 AM -
Why are most cutters so crap?
By Tenson in forum General DiscussionReplies: 5Last Post: 17-10-2015, 01:51 PM -
Chinese 6040 CNC Router Advise Needed
By Bob Hepple in forum Chinese MachinesReplies: 24Last Post: 27-11-2013, 12:00 PM
Bookmarks