. .
  1. #1
    Ok for all you engineers out there.

    I have two O-rings one id 6mm & 2mm cross section and another id 7mm & 1.5 cross section.

    I have a bore of 10mm and a piston 9.96mm. What size groove do I need in the piston for hydraulic dynamic use (this is for a powered draw bar) the piston will move about 7mm in the bore.
    ..Clive
    The more you know, The better you know, How little you know

  2. #2
    Hi Clive
    Information should be in there .
    https://www.jameswalker.biz/en/pdf_docs/3-o-ring-guide
    Regards
    Mike

  3. #3
    Clive,

    I design pressure systems up to 30ksi. For up to 15ksi, the starting point is the Parker catalogue:

    http://www.parkerhannifin.ru/upload/...ode5712_en.pdf

    In most cases, imperial o-rings are easier to source but there is always a metric equivalent.
    https://emvioeng.com
    Machine tools and 3D printing supplies. Expanding constantly.

  4. The Following User Says Thank You to komatias For This Useful Post:


  5. #4
    Mike & George Many thanks for the homework you have provided for me. I have found this as well https://oringcalculator.eriksgroup.com/# but I can't seem to get the answer from it. So I will sit down and bang my head against the wall for a bit
    ..Clive
    The more you know, The better you know, How little you know

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How-To: Feed Rate Calculation
    By Lee Roberts in forum Machine Discussion
    Replies: 20
    Last Post: 25-03-2020, 04:09 PM
  2. pulse equivelant calculation
    By yasser in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 17-05-2016, 10:10 AM
  3. One ring to rule them all?
    By Rufe0 in forum Gantry/Router Machines & Building
    Replies: 51
    Last Post: 27-01-2016, 04:15 AM
  4. Simple O-ring calculator.
    By jcb121 in forum General Computing
    Replies: 4
    Last Post: 26-07-2013, 09:00 PM
  5. how to measure a ring for cnc.
    By crimsonred in forum Probing, Digitizing & Scaning
    Replies: 4
    Last Post: 27-09-2010, 02:47 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •