Thread: Single point thread tools
Threaded View
-
20-03-2017 #6
Robin,
It's not in the least bit scary, I've never broken a cutter and I've cut internal threads down to M3.
Provided you run at the recommended rpm you are fine, air + mist lube is sufficient to clear chips and lube the tool and the lovely part is that if you need to or if you are prototyping you can take multiple passes until you get where you need to be ;-)
Regards,
NickYou think that's too expensive? You're not a Model Engineer are you? :D
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Single Point Thread Mills
By matt-b2 in forum General DiscussionReplies: 9Last Post: 18-01-2016, 08:06 PM -
CONVERSION: Re-Built a used CNC mill machine to the point of 80%
By dudz in forum Conversion Build LogsReplies: 13Last Post: 20-03-2014, 06:44 PM -
Setting the zero point on a CNC lathe
By Robin2 in forum Lathes, Lathe Rebuilding & ConversionsReplies: 7Last Post: 20-10-2013, 10:37 PM -
Setting the zero point on a CNC lathe
By Robin2 in forum Machine DiscussionReplies: 7Last Post: 20-10-2013, 10:37 PM -
Setting a start point.
By jrob3rts in forum Computer SoftwareReplies: 14Last Post: 17-06-2012, 12:36 PM
Bookmarks