Thread: DIY Pin Badge

Page 2 of 2 FirstFirst 12
  1. #11
    Wal I love these too. Well done again and thanks for Sharing.

    Sent from my iPhone using Tapatalk

  2. #12
    Wal, these are very nice and inspiring. What is it you fill them with and how deep are you milling them?

  3. #13
    Wal's Avatar
    Lives in Stockport, United Kingdom. Last Activity: 5 Days Ago Has been a member for 5-6 years. Has a total post count of 290. Received thanks 26 times, giving thanks to others 11 times.

    I use cold enamel - like this:

    It's good stuff, but can be tricky to mix in small quantities, ie. 0.1gm colour + 1.9gm resin +1gm hardener. Too much/too little of one or the other and it doesn't set properly..!

    If I'm using >0.8mm cutters I'll cut to a depth of 0.75mm, anything under that I'll keep to around 0.5mm - in both cases it's probably too deep, but I get paranoid about belt sanding through the epoxy..!


  4. The Following User Says Thank You to Wal For This Useful Post:

  5. #14
    Did you check the job request for aluminum badge?
    project 1 , 2, Dust Shoe ...

Page 2 of 2 FirstFirst 12


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts