Wal I love these too. Well done again and thanks for Sharing.
Sent from my iPhone using Tapatalk
Wal, these are very nice and inspiring. What is it you fill them with and how deep are you milling them?
I use cold enamel - like this:
It's good stuff, but can be tricky to mix in small quantities, ie. 0.1gm colour + 1.9gm resin +1gm hardener. Too much/too little of one or the other and it doesn't set properly..!
If I'm using >0.8mm cutters I'll cut to a depth of 0.75mm, anything under that I'll keep to around 0.5mm - in both cases it's probably too deep, but I get paranoid about belt sanding through the epoxy..!
The Following User Says Thank You to Wal For This Useful Post:
Did you check the job request for aluminum badge?