1. #1
    Lenze's new VFD at our paper plant trips on earth fault immediately on receiving a start command. It happens even when no motor and leads are connected. What could be the reason for tripping? Would adding a ground fault sensor help?

  2. #2
    The drive probably has Internal EMC filter which will need disconnecting. Probably Screw on the side but the manual should tell you.

  3. #3
    there are 2 options not to open it.
    1 use higher protection current 500mA
    2 connect before protection device if possible

    reason as jazzcnc mentioned EMC filter

    Poslano sa mog MI 5 koristeći Tapatalk

Similar Threads

  1. 2.2KW 3HP Inverter help
    By adamh in forum Spindles & Drive Motors
    Replies: 8
    Last Post: 31-07-2015, 08:21 AM
  2. Broken transformer in Lenze Speed Control 530.
    By Samuel59 in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 23-04-2014, 11:22 AM
  3. WANTED: Electrical Box for inverter
    By badgerman in forum Items Wanted
    Replies: 1
    Last Post: 28-09-2013, 10:08 PM
  4. Very Sick Lenze 534 Controller
    By Ricardoco in forum Motor Drivers & Controllers
    Replies: 29
    Last Post: 30-09-2012, 04:52 PM
  5. Lenze 534
    By Ricardoco in forum Milling Machines, Builds & Conversions
    Replies: 12
    Last Post: 29-07-2012, 08:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •