1. Hi Guys, i have been hiding for a while, so long infact i think i have forgotten how to use this post,
    So a problem has started to happen, generally when i set up a new job and zero the z either with a touch plate or by eye when i run the program the z is now +4mm above where i set zero, anyone have any clues to this
    Thanks roger CNCEzee

  2. #2
    Neale's Avatar
    Lives in Plymouth, United Kingdom. Last Activity: 7 Hours Ago Has been a member for 5-6 years. Has a total post count of 1,156. Received thanks 209 times, giving thanks to others 5 times.
    Does your tool-zeroing macro have the right dimension for the touchplate? Let's start with the obvious ones

  3. Hi Neale, Thanks for replying.
    well i think so, what seems to happen is that the tool tip will touch off raise the required amount stop briefly then raise another 4mm, software coding is the quickest way there is of confusing me, i will strip out that code and try it with out.

    Roger

  4. #4
    You haven't got a 4mm work offset in the tool change tab have you?

    Sent from my HUAWEI VNS-L31 using Tapatalk
    Neil...

    Build log...here

  5. Good Question, i don't know but i will check when i get down there.

  6. No Not any tool or work offsets

  7. No just checked also just removed code from touch plate, zeroed the maching cilcked go to zero zeroed perfectly, run tool code machine is +4mm stop machine re-zeroed runs as should...GRRRRRRR

Similar Threads

  1. Auto zero Z axis problems
    By Jumbo in forum Probing, Digitizing & Scaning
    Replies: 26
    Last Post: 23-10-2016, 02:00 PM
  2. Mach3 Problems problems problems.
    By ECCO in forum Artsoft Mach
    Replies: 18
    Last Post: 09-07-2016, 09:07 AM
  3. MACH 3 2010 Screenset Zeroing Macros
    By Washout in forum Artsoft Mach
    Replies: 5
    Last Post: 12-01-2014, 12:15 PM
  4. Replies: 11
    Last Post: 01-01-2014, 08:01 PM
  5. Boxford VMC190 Retrofit Problems, axis sounds very rough
    By mikegolding in forum Boxford Vertical Mills
    Replies: 5
    Last Post: 09-06-2013, 08:11 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •