1. #1

    Sorry if this is a stupid question, but I just need to confirm the following please.

    The markings/labels on my AM882 stepper driver are: PUL, DIR & ENA

    I believe these translate as follows:

    PUL = Pulse Signal which = or is the same as Step signal or Stepping pulse, or just STEP
    DIR = Direction Signal.
    ENA = Enable Signal. This signal is used for enabling/disabling the driver.

    Am I correct??


  2. #2
    Ger21's Avatar
    Lives in Detroit, United States. Last Activity: 20 Hours Ago Has been a member for 6-7 years. Has a total post count of 603. Received thanks 83 times, giving thanks to others 0 times. Referred 1 members to the community.
    yes, you are correct.
    UCCNC 2017 Screenset

    Mach3 2010 Screenset

    JointCAM - CAM for Woodworking Joints

  3. #3
    Thanks for the quick reply.


Similar Threads

  1. Step-Four problems
    By BazzerH in forum General Discussion
    Replies: 4
    Last Post: 22-02-2017, 05:28 PM
  2. BUILD LOG: Sweet dreams CNC - more than one step beyond...
    By sweetdream in forum DIY Router Build Logs
    Replies: 33
    Last Post: 23-10-2014, 03:08 PM
  3. Step drill bits (where to get) ?
    By Gytis in forum Marketplace Discussion
    Replies: 10
    Last Post: 06-08-2013, 11:04 PM
  4. Step 4 router
    By John S in forum Milling Machines, Builds & Conversions
    Replies: 9
    Last Post: 11-08-2009, 03:16 PM
  5. Step clamp
    By Lee Roberts in forum Programmers Corner
    Replies: 0
    Last Post: 14-10-2008, 01:39 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts