Thread: 1200mmX900mmX170mm 4axis cnc
-
18-04-2018 #221
UC300 with UB1 will cost 320$ with out shipping and taxes,this is far away from badget right now.....
Last edited by Nickhofen; 18-04-2018 at 08:49 AM.
-
The Following User Says Thank You to Nickhofen For This Useful Post:
-
18-04-2018 #222
I feel your pain, that's why I setup with PP BOB originally as the budget just wouldn't stretch over Xmas period so I could play with it, do some calibration and decide if I got on with linuxcnc before spending £300 on hardware which locks me into a vendor I haven't even tried.
I remember you saying you've used mach before so being locked in is probably not an issue to you.
When I was able to sell a kidney I got my electronics ;)
Ironically now I have a machine with good latency I can run it at 9m/min no issues from the PP BOB with 8 microsteps which has made the mesa less essential but obviously I'm still going to use it.http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
-
18-04-2018 #223
Yes you remember correctly,I am going to use Mach3 again.
My new senario is to take the uc300eth-5LPT and a crap break out board until I decide which of two kidney to sell,haha!!
-
18-04-2018 #224http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
-
18-04-2018 #225
-
20-04-2018 #226
-
21-04-2018 #227http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
-
21-04-2018 #228
-
28-04-2018 #229
I am ready to purchase the pulleys 20 Teeth HTD 5M for XY axis 1:1,at X and Y I use 1610 ballscrews.
At Z I have 1605 ballscrew what rate is recommended to use at the pulleys 1:2 maybe?
-
28-04-2018 #230
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
cnc 4axis hot wire mach3;
By maikonesk in forum Hotwire Cutting MachinesReplies: 3Last Post: 07-08-2015, 02:15 PM
Bookmarks