Threaded View
-
10-10-2017 #11
Yes those are supposed to go the spindle, no biggy just swap them to the correct terminals on the PCB.
Do you know what the draw is of the spindle? I would advise against running that new PSU for the spindle through that On / Off switch, i would just power the Spindle PSU direct from the IEC / Kettle Plug, if you want to be able to turn it on & off away from using the wall plug, then get one of those additional IEC / Kettle Plug mounts from ebay like i linked.
You need to wire that PCB to the Spindle PSU, just take 'Power -' on the PCB to a 'V-' terminal on the PSU and the same for 'Power +' to 'V+'.
That should be all you need to do in terms of power.
Cheers
Alex
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
3020T Capabilities
By TT901 in forum Chinese MachinesReplies: 6Last Post: 03-03-2017, 04:20 PM -
Chineese 6040 problems
By Kendrick57 in forum Gantry/Router Machines & BuildingReplies: 18Last Post: 18-10-2015, 10:52 PM -
Ballscrew for 3020T Y Axis
By richie00boy in forum Lead Screws, Nuts & SupportsReplies: 5Last Post: 02-08-2013, 02:47 PM -
A viable mini-ish-mill build, or a hiding to nothing..?
By Wal in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 02-07-2013, 07:33 PM -
Where did you buy your threaded rod?(cheapo leadscrew!) - was it straight?
By HankMcSpank in forum Marketplace DiscussionReplies: 18Last Post: 04-06-2009, 03:44 PM
Bookmarks