. .
  1. #1
    I have been using mach3 for turning for ages now and the program that generates the code has been set to swap g2 for g3 and visa versa . Why do I have to and can I set anything in mach3 to swap the two I/e make G2 DO WHAT ITS SUPOSED TO DO.

  2. #2
    It sounds like the post processor was modified, if so you should undo the changes there rather than change anytihng in Mach3.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

  3. #3
    Thanks for looking . I had to modify the post processor to get the correct rotation. but I would like to have it unmodified because if I do any manual editing I have to remember to put G3 For G2 and G2 forG3 , I will make a mistake one day and may be a big bang.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. very HOT spindle, what have I done wrong?
    By mikeconcannon in forum Generic Chinese Spindles
    Replies: 8
    Last Post: 02-05-2017, 03:46 PM
  2. CNC gone wrong
    By martythunder in forum General Discussion
    Replies: 6
    Last Post: 16-02-2017, 04:21 PM
  3. When it all goes wrong
    By alboy in forum General Discussion
    Replies: 2
    Last Post: 12-12-2015, 01:16 AM
  4. What has gone wrong????
    By Davek0974 in forum Plasma Table Machines
    Replies: 54
    Last Post: 05-09-2014, 12:25 AM
  5. Ok, so whats wrong?
    By Davek0974 in forum 3D Printing Machines
    Replies: 32
    Last Post: 27-03-2014, 12:19 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •