Thread: Insert Based Endmills
Threaded View
-
18-07-2017 #1
I am considering this. Cutwel are doing a 'free' holder if you order 20 inserts. Around £150 landed cost. Not cheap however this might be more efficient than buying endmills in the longer run.
https://www.cutwel.co.uk/milling-too...y-ams-s-series
Thoughts? Suitability on a high speed spindle setup? From the supplied chipload per tooth, I should be pushing around 20K RPM and north of 6000mm/min (assuming I can power this much of cut).
Thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Long bits/endmills
By dcrowder in forum Machine DiscussionReplies: 4Last Post: 24-03-2016, 10:18 AM -
CNC Project - Collet Drawer Insert
By Washout in forum Woodworking Project ShowcaseReplies: 4Last Post: 08-07-2015, 08:12 AM -
Do such endmills exist?
By HankMcSpank in forum Tool & Tooling TechnologyReplies: 5Last Post: 04-04-2013, 11:52 PM -
cnc cutting tool tungsen caride milling and turning insert
By pipiyjj in forum Manufacturer NewsReplies: 0Last Post: 22-03-2012, 02:43 AM -
Chipload and DOC for small endmills
By Jonathan in forum Tool & Tooling TechnologyReplies: 15Last Post: 16-01-2011, 04:12 PM
Bookmarks