1. #1
    Lodds's Avatar
    Lives in Feltham, United Kingdom. Last Activity: 6 Hours Ago Has been a member for 0-1 years. Has a total post count of 12.
    Guys,

    Just getting to grips with my machine and it is finally obeying my instructions.

    Please can someone advise me of the possible cause of torn fibres when engraving text. By torn fibres I mean that all round the text the wood is frayed and making it almost impossible to see what the text is. I was using a 90 degree pointed router bit from my normal router set. Router speed was around 16 - 20000.
    Not sure if the bit, speed or both causing this problem, appreciate your thoughts

    Tony

  2. #2
    I'm certainly not a wood expert, but some types of wood will be worse than others - what are you cutting?

    If using a v-point then it just needs to be as sharp as possible, if using endmills then downcut can be useful for a clean edge assuming you can evacuate the chips effectively.

    I assume you've tried just giving it a once over with some fine sand paper to de-burr the edges?

  3. The Following User Says Thank You to Zeeflyboy For This Useful Post:


  4. #3
    Lodds's Avatar
    Lives in Feltham, United Kingdom. Last Activity: 6 Hours Ago Has been a member for 0-1 years. Has a total post count of 12.
    Quote Originally Posted by Zeeflyboy View Post
    I'm certainly not a wood expert, but some types of wood will be worse than others - what are you cutting?
    Thanks for the info. I'm cutting MDF and a bit of Iroko (think that is how it is spelled)

    I have lots of bit hanging around, looks like a trial and error format is called for.

  5. #4
    Ger21's Avatar
    Lives in Detroit, United States. Last Activity: 12 Hours Ago Has been a member for 5-6 years. Has a total post count of 508. Received thanks 68 times, giving thanks to others 0 times. Referred 1 members to the community.
    With MDF, the quality of the MDF, and the sharpness of the bit, will make a big difference.
    Gerry
    ______________________________________________
    UCCNC 2017 Screenset

    Mach3 2010 Screenset

    JointCAM - CAM for Woodworking Joints

  6. The Following User Says Thank You to Ger21 For This Useful Post:


Similar Threads

  1. Syil X4 Plus - E-stop issue
    By Keith-h in forum Milling Machines, Builds & Conversions
    Replies: 8
    Last Post: 03-12-2016, 05:53 PM
  2. Exact stop / CV problems
    By fvfdrums in forum Gantry/Router Machines & Building
    Replies: 0
    Last Post: 31-08-2015, 01:27 PM
  3. Spindle Stop?
    By manofgresley in forum Spindles & Drive Motors
    Replies: 21
    Last Post: 08-01-2013, 06:37 PM
  4. E-STOP Circuit - will this cause any problems?
    By birchy in forum General Electronics
    Replies: 34
    Last Post: 18-12-2012, 04:35 AM
  5. wiring e-stop button
    By deannos in forum General Electronics
    Replies: 10
    Last Post: 14-01-2012, 11:03 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •