Page 2 of 2 FirstFirst 12
  1. #11
    Is that slow enough?

  2. #12
    Hi Richard
    I would imagine so it's very thin (has to be sucked through 10mm pipe) and i would imagine it should level fairly rapid. The guys are obviously using the West Epoxy for a reason so search the forum as there is a thread dedicated to epoxy leveling.From recollection i can't remember anyone mentioning infusion resin and that seemed a bit strange but there could be a reason, also that link is possibly not the cheapest so if you decide to go with it have a look round for the best price.
    regards
    Mike
    Last edited by mekanik; 5 Days Ago at 01:51 PM.

  3. #13
    There's a glass fibre and carbon moulding place near me, who have done a few things for me. They might be able to get something cheaper.

    They always want resin that goes hard really fast, so fast it gets really really hot, but they might be worth asking.

  4. #14
    I think the last time i did an infusion job the open time was about 30min before it started to gel, i would imagine that's more than enough time to level,Comments from our machine constructors would be helpful.

  5. #15
    Quote Originally Posted by mekanik View Post
    I think the last time i did an infusion job the open time was about 30min before it started to gel, i would imagine that's more than enough time to level,Comments from our machine constructors would be helpful.
    have used the west system a few times the slow one take about 6 hours in free state I think curing is about 20 hours and then do not touch for about 7-10 days
    ..Clive
    The more you know, The better you know, How little you know

Page 2 of 2 FirstFirst 12

Similar Threads

  1. BUILD LOG: Aluminium profile CNC
    By BriceO in forum DIY Router Build Logs
    Replies: 27
    Last Post: 10 Hours Ago, 08:21 PM
  2. Aluminium Profile
    By amxen in forum Metalwork Discussion
    Replies: 2
    Last Post: 13-08-2015, 07:37 PM
  3. Aluminium Profile - ValuFrame?
    By Tenson in forum Marketplace Discussion
    Replies: 10
    Last Post: 28-06-2012, 02:20 PM
  4. Tapping Aluminium profile
    By jonbabbz in forum Tool & Tooling Technology
    Replies: 3
    Last Post: 28-05-2012, 08:09 AM
  5. Aluminium Extrusion suppliers?
    By m_c in forum General Discussion
    Replies: 3
    Last Post: 12-04-2011, 01:23 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •