1. #1
    I am making small side tables out of 12mm MDF with oak veneer on both sides, realise an up or down spiral cut will not get a good edge on one of the sides.

    Looking at 6mm compression and straight 2 blade flutes.

    These seem to be very expensive. Does any one know of a supplier who does them at a reasonable price?

    I know not to use HSS. Only carbide. I have purchased up /down cut ones (that are very cheap and lasted well). Just cant find compression ones.

    Last edited by Straker; 11-11-2017 at 03:23 PM.

  2. #2
    Last edited by cropwell; 11-11-2017 at 09:14 PM.
    Albert Einstein may have been a genius, but his brother Frank, was a monster

    Sent from my clunky old Windows 7 Machine

Similar Threads

  1. Feeds and speeds settings for compression spiral
    By Metal pecker in forum General Discussion
    Replies: 2
    Last Post: 02-07-2016, 06:41 PM
  2. Compression Bit Advice
    By dcrowder in forum Machine Discussion
    Replies: 4
    Last Post: 17-04-2016, 10:27 PM
  3. Machine Light(Lathe) anything reasonably priced
    By mekanik in forum Workshop & Equipment
    Replies: 17
    Last Post: 24-02-2016, 07:58 PM
  4. Has anyone used this Chinese supplier?
    By D.C. in forum Marketplace Discussion
    Replies: 0
    Last Post: 29-07-2015, 01:37 PM
  5. Can you recommend a UK Supplier for cnc router bits
    By GeoDurie in forum Tool & Tooling Technology
    Replies: 0
    Last Post: 06-06-2014, 10:40 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts