1. #1
    JOGARA's Avatar
    Lives in Derby, United Kingdom. Last Activity: 3 Hours Ago Has been a member for 1-2 years. Has a total post count of 293. Received thanks 11 times, giving thanks to others 54 times.
    ON HOLD - We are evaluating if we can manufacture these ourselves or not. Will open up for quotes again soon if we can't.


    All files located in .zip bellow.

    50x Top and Bottom
    AIO top.stl
    AIO bottom.stl

    90degree angles can be milled with 3mm bit.
    Curved bit at the top can be stepped at 0.1mm using 3mm bit. Yes 3mm floor is fine.
    3 square holes can be milled with 2mm bit on the 90 degree corners.
    1mm chamfer required on rear side around the edges and 3 holes.
    The 4 pillars are actually a drill hole size of 2.5mm not 1.6mm, will update later.


    75x Top and Bottom
    RP top.stl
    RP bottom.stl

    3 square and large rectangle holes can be milled with 2mm bit on the 90 degree corners.
    1mm chamfer required on rear side around the edges and 3 holes and large rectangle hole.
    The 2 pillars and other 1.6mm hole are actually a drill hole size of 2.5mm not 1.6mm, will update later.


    35x Top and Bottom
    S top.stl
    S bottom.stl

    90degree angles can be milled with 3mm bit.
    3 square holes can be milled with 2mm bit on the 90 degree corners.
    1mm chamfer required on rear side around the edges.


    If you have the ability to tap on machine, all 2.5mm holes can be tapped M3, rear large hole on bottom parts is 1/4-20.
    I can do the tapping if it adds to the cost too much.


    https://drive.google.com/open?id=1F7...YyKvIIJk2HwR31
    Last edited by JOGARA; 01-12-2017 at 10:42 AM.

Similar Threads

  1. Machine cases and covers for 3D Printers
    By Protopro in forum Manufacturer News
    Replies: 0
    Last Post: 01-11-2017, 07:59 PM
  2. RFQ: Small run of parts in aluminium
    By CHudson in forum Projects, Jobs & Requests
    Replies: 0
    Last Post: 06-10-2017, 03:12 PM
  3. angular contact bearings - back to back, further apart
    By dsc in forum Linear & Rotary Motion
    Replies: 16
    Last Post: 05-01-2014, 09:59 PM
  4. RFQ: 2 x Headphone Amp cases machined from Walnut.
    By SamW in forum Projects, Jobs & Requests
    Replies: 8
    Last Post: 20-04-2013, 08:03 AM
  5. Drivers,BOB and PSU are in a PC case, do i earth the case
    By deannos in forum Motor Drivers & Controllers
    Replies: 4
    Last Post: 27-11-2011, 02:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •