Page 2 of 2 FirstFirst 12
  1. #11
    spiral or ramp it in, I have been getting the real cheap ones from banggood and had good results and about 1-3 each depending on size
    Last edited by charlieuk; 3 Weeks Ago at 12:01 AM.

  2. #12
    Quote Originally Posted by charlieuk View Post
    spiral or ramp it in, I have been getting the real cheap ones from banggood and had good results and about 1-3 each depending on size
    Carbide or HSS?

  3. #13
    carbide

  4. #14
    Plunging can leave marks on the edge, ramping into the cut is a far better method.

    Measure the thickness of the MDF, if it's more than nominal then it likely has moisture content and that can make it fluffy.
    ONLY if it's dry, a coat of spirit sanding sealer helps to keep it dry and also penetrates and consolidates the surface making for a crisper edge.
    Last edited by EddyCurrent; 3 Weeks Ago at 01:30 PM.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

Page 2 of 2 FirstFirst 12

Similar Threads

  1. NEW MEMBER: Greetings and a question
    By Jono in forum New Member Introductions
    Replies: 6
    Last Post: 04-04-2017, 12:06 PM
  2. VFD Question
    By Chaz in forum Motor Drivers & Controllers
    Replies: 9
    Last Post: 14-01-2017, 08:41 PM
  3. PSU question
    By iforeman in forum General Electronics
    Replies: 6
    Last Post: 23-11-2016, 10:56 PM
  4. question ...
    By Wobblybootie in forum General Discussion
    Replies: 6
    Last Post: 04-01-2010, 12:04 AM
  5. A question
    By bodgeitandscarper in forum Gantry/Router Machines & Building
    Replies: 7
    Last Post: 02-12-2009, 08:30 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •