Thread: Uccnc hdbb2 wiring help needed
Threaded View
-
07-12-2017 #1
I've got myself a uccnc hd bb2 bob that has rj45 connectors. Balazs at uccnc explained that the axis connections are as follows
HDBB2 RJ45 pin 1. step --- Drive Pul+
HDBB2 RJ45 pin 2. dir --- Drive Dir+
HDBB2 RJ45 pin 3. gnd --- Drive Pul-
HDBB2 RJ45 pin 3. gnd --- Drive Dir-
I will be wiring to 3 leadshine em705 digital drivers. Would I be correct in assuming that I could link DIR- and PULSE- on the stepper itself ? Or is there a better way to wire the drivers with this BOB ?
Cheers
AndrewLast edited by the great waldo; 07-12-2017 at 09:45 PM. Reason: spelling
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
UCCNC MyProbe error
By chipxx in forum CNCdrive (UCCNC)Replies: 0Last Post: 22-08-2017, 02:36 PM -
Schneider Altivar 320 wiring / setup help needed
By TadasM in forum Spindles & Drive MotorsReplies: 31Last Post: 21-10-2016, 07:43 AM -
UCCNC and Rodocutter X4 Problems
By RusticRusty in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 06-06-2015, 09:01 PM -
PSU wiring help needed
By Boyan Silyavski in forum General ElectronicsReplies: 7Last Post: 25-06-2014, 11:46 AM -
Driver wiring advice needed...
By Wal in forum General ElectronicsReplies: 17Last Post: 09-06-2014, 06:11 PM
Bookmarks