1. #1
    I bought a Chinese CNC 4030 a couple of years ago and have been using it without any real problem until recently when the controller board blew one axis controller.
    I replaced it with the tb6560 3-axis controller and got it set up and working...BUT... it will only work at very low speeds, it's like it has no torque and is mossing steps even without any load on the machine (not cutting).
    I've read through all settings and can't work out what is wrong. It is using the original Chinese Steppers but they worked fine with the old controller which was a lower current maximum.
    Any help appreciated, thanks
    Last edited by Wayne B; 21-01-2018 at 04:35 PM.

  2. #2
    There is no "the tb6560 3-axis controller", there are dozens of the buggers knocked out by all and sundry in China! ;-)
    Photos and links including product specific documentation will help the class address your questions. :D
    You can buy the TBxxxx chips very cheaply, have you considered fixing your original board?

    Another thing to consider when replacing a 3-axis board when one axis fails is to buy separates - a BOB and 3 single axis controllers + 1 spare, then when you pop an axis you have a swap out and/or can use working parts from one axis to identify the exact location of the fault on another,
    Regards,
    Nick
    Last edited by magicniner; 21-01-2018 at 05:06 PM.
    You think that's too expensive? You're not a Model Engineer are you? :D

  3. #3
    Doddy's Avatar
    Lives in Preston, United Kingdom. Last Activity: 6 Hours Ago Has been a member for 4-5 years. Has a total post count of 295. Received thanks 34 times, giving thanks to others 10 times.
    Just a thought - have a look at the step/direction pulse width within Mach3 (if this is what you're using). Fiddle the value to be longer (e.g. 5us) and see if this helps any.

  4. #4
    Thanks for the reply's. In true fashion, I finally gave in and asked then went back to it and tried more things. I changed the step setting to 1/8 from 1/16 and slowed it down considerably (although the old speed setting worked with the original controller) and got it working. I will try changing the pulse widths too as I'm still not 100% with it right now, although it is getting things cut for now.
    More settings testing to follow....

Similar Threads

  1. Replies: 5
    Last Post: 29-09-2014, 01:42 PM
  2. tb6560
    By uppy121 in forum Motor Drivers & Controllers
    Replies: 7
    Last Post: 08-04-2013, 09:39 AM
  3. 1 axis tb6560 any good?
    By lazzymonk in forum Motor Drivers & Controllers
    Replies: 15
    Last Post: 08-08-2012, 06:58 AM
  4. Replies: 9
    Last Post: 08-06-2012, 11:12 AM
  5. Interact series 2 speed controller problem
    By fastcarl in forum Machine Discussion
    Replies: 1
    Last Post: 25-01-2011, 08:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •