1. #1
    As the title DIYCNC version 2 board does anybody have a manual please?
    ..Clive
    The more you know, The better you know, How little you know

  2. #2
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    You think that's too expensive? You're not a Model Engineer are you? :D

  3. #3
    Quote Originally Posted by magicniner View Post
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    Yes thanks I had checked that. I am using this as an experiment because it can accept at 15-70 V and then give out 12V and 5V with its built in regs. I am also using one of those crap Chinese bobs to drive a mill with 3 mpg's and separate homing on each axis. with Linuxcnc. The crap board needs 12-24V plus 5V. I will then have 10 inputs 6 for the mpg's and 3 for the homing etc.
    Last edited by Clive S; 10-03-2018 at 09:32 AM.
    ..Clive
    The more you know, The better you know, How little you know

  4. #4
    So if it didn't feature anywhere on DIYCNC's site is it one of the currently available Chinese boards?
    You think that's too expensive? You're not a Model Engineer are you? :D

  5. #5
    Quote Originally Posted by magicniner View Post
    I looked back through their website's various incarnations and couldn't find a Version 2 board

    https://web.archive.org/web/*/www.DIYCNC.co.uk
    That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.

  6. #6
    Quote Originally Posted by JAZZCNC View Post
    That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.
    Thanks for the manual Dean
    ..Clive
    The more you know, The better you know, How little you know

Similar Threads

  1. What happened to DIYCNC.co.uk ?
    By RocketBoy in forum General Electronics
    Replies: 4
    Last Post: 23-05-2017, 07:14 PM
  2. Roy's DIYCNC System 3 board
    By John S in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 24-03-2017, 11:50 AM
  3. Replies: 0
    Last Post: 13-02-2014, 06:09 PM
  4. Nice one Roy at DIYCNC
    By routercnc in forum Motor Drivers & Controllers
    Replies: 9
    Last Post: 26-10-2010, 01:31 PM
  5. Wiring in power and E-stop on DIYCNC Board
    By m.marino in forum General Electronics
    Replies: 2
    Last Post: 10-05-2009, 09:15 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •