which wire for stepper driver to socket on control box

[the great waldo]

Hello all

I finally gave up the idea of upgrading my old makko 850 with acme threads and went for one of these https://www.sorotec.de/shop/Portal-m...-DIY-4863.html
I am in the process of wiring up the control box and will be basing it on this wiring diagram http://www.sorotec.de/webshop/Bedien...uerung_pro.pdf I am using leadshine em705 drivers and was wondering if one has to use screened cable from the driver to the socket for the stepper on the case or is normal stranded wire ok? thanks in advance.
cheers
Andrew

[JAZZCNC]

was wondering if one has to use screened cable from the driver to the socket for the stepper on the case or is normal stranded wire ok? thanks in advance.
cheers
Andrew

Ideally you would use Screened cable but if it's short run and not located near high voltage wires ie: Mains voltage then you'll be fine.

[the great waldo]

Hi Jazz.
Thanks for the info it. It is a short run but i'll go for screened wire. Any idea about wire specs on the wire? The steppers are just over 4amps https://www.sorotec.de/shop/Stepping...M-Nanotec.html tia.
Cheers.
Andrew

[JAZZCNC]

Hi Jazz.
Thanks for the info it. It is a short run but i'll go for screened wire. Any idea about wire specs on the wire? The steppers are just over 4amps https://www.sorotec.de/shop/Stepping...M-Nanotec.html tia.
Cheers.
Andrew

0.75mm2 CY cable is what you need.

[the great waldo]

Hi Jazz.
Thank you for the info and your time.
Cheers.
Andrew

[the great waldo]

Hi Jazz
One last question (I promise) regarding wire specs, Sorotec sent me 0.5 mm wire with the set, is it worth the effort to go for 0.75mm wire. I'll stick with this machine until i'm pushing up the daisys so I don't mind putting in a bit of effort in getting things right now.
Cheers.
Andrew