1. #1
    Just ordered a couple of these for a project and thought others may find them useful

    Link: https://www.ebay.co.uk/itm/132411077076

    Video of one use:

    .Me

  2. The Following User Says Thank You to Lee Roberts For This Useful Post:


  3. #2
    Just had an email through about a 24v version of this, may be better for those running a 24v setup.

    Link: https://www.ebay.co.uk/itm/282258800401
    .Me

  4. #3
    Well that is very confusing! Is it a variable frequency generator to drive a stepper motor (it says that a separate drive is needed) or a PWM controller? There's a meaty device with a heatsink but maybe that's just a regulator as it says that you can supply from 160 V.

  5. #4
    The guy in the video likes living dangerously - drilling holes in an ali block holding the rough cut edges in his fingers! And I don't know if it's the effect of the camera, the playback or what but at low speed the stepper seems to be very jerky.
    Last edited by JohnHaine; 15-07-2018 at 08:57 AM.

  6. #5
    Well he's still got ten fingers and not too many scars, so he must be doing something right !
    Cheers

    Andrew
    Last edited by the great waldo; 15-07-2018 at 11:24 AM.

  7. #6
    Quote Originally Posted by JohnHaine View Post
    Well that is very confusing! Is it a variable frequency generator to drive a stepper motor (it says that a separate drive is needed) or a PWM controller? There's a meaty device with a heatsink but maybe that's just a regulator as it says that you can supply from 160 V.
    Either, it depends on the jumper setting.
    Albert Einstein may have been a genius, but his brother Frank, was a monster

    Having just moved to Windows 10 (which is crap) My stress levels are through the roof !!!

  8. #7
    Quote Originally Posted by the great waldo View Post
    Well he's still got ten fingers and not too many scars, so he must be doing something right !
    Cheers

    Andrew
    And no thumbs
    ..Clive
    The more you know, The better you know, How little you know

  9. #8
    Quote Originally Posted by the great waldo View Post
    Well he's still got ten fingers and not too many scars, so he must be doing something right !
    Cheers

    Andrew
    Well, so far it hasn't gone wrong!

Similar Threads

  1. Replies: 2
    Last Post: 17-11-2017, 04:24 PM
  2. pulse generator for M542
    By gnalbant in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 03-07-2016, 10:50 AM
  3. Stepper motor Pulse Signal Generator module
    By Tom J in forum Motor Drivers & Controllers
    Replies: 8
    Last Post: 12-01-2016, 10:47 AM
  4. Stepper motor as a generator??
    By wiatroda in forum General Discussion
    Replies: 10
    Last Post: 08-08-2011, 09:17 PM
  5. Motor controller next to break out board?
    By m_c in forum General Electronics
    Replies: 2
    Last Post: 17-11-2010, 12:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •