Threaded View
-
01-05-2018 #1
Hi there
I am trying to install my 3 phase Spindle using a Delta 7.5 KW Inverter.
At the moment I can connect to output1 of my BOB(Smooth Stepper) Trough Mach3 by pressing the (Spindle CW F5) Bottom of Mach3, as the result The corresponding Light In front of it (Output1 in my BOB, I am attaching a Picture of it) will light Up. In the picture Output1 corresponds to O1. Also I can connect it to my Inverter, therefore I can Run/stop Spindle from mach3.
But I just cannot light up the PWM corresponding Light in my BOB from Mach3
What is it wrong in my mach3 setup? Presently I am dedicating Output1 to Run and/or Stop the spindle, but also, I think I am trying to use the same output1 to connect to my PWM , I really cannot figure it out, any advice is greatly appreciated.
Regards
Jhonansaro
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
digital to analog servos
By elad1987 in forum Control Hardware & SystemsReplies: 3Last Post: 15-06-2017, 09:59 PM -
Anyone controlling their Huanyang VFD with an analog control voltage?
By Ger21 in forum Generic Chinese SpindlesReplies: 9Last Post: 16-04-2017, 06:38 PM -
Output voltage from mains driver?
By JW1977 in forum Motor Drivers & ControllersReplies: 8Last Post: 24-03-2017, 01:33 PM -
5-axis Breakout Includes Hand-Held Control Port & 3,4,5-axis Postion-Display Port
By LoveLearn in forum General ElectronicsReplies: 12Last Post: 25-05-2013, 12:41 AM -
parralell port voltage.
By crossleymarko in forum Computer HardwareReplies: 71Last Post: 15-04-2012, 09:55 PM
Bookmarks