Hello, I've been using a Stepcraft 420 for a couple of years making parts for a microlight aeroplane from sheet aluminium. I was going to build a bigger, stiffer machine after much reading on here, but ended up buying the router member "Bigstu" built. Its a dual x-drive, 4'x4' aluminium frame gantry router, now filling a large part of my workshop!

I've now done the bits to the machine that bigstu hadn't gotten round to, namely tidying up the electronics and painting the steel parts. The initial flush of new ownership! With a bit of the usual set-up faffing, having had to pull it to bits to fit in a Volvo, its now working and producing parts 10x faster than the little stepcraft managed. But the stepcraft was an excellent introduction to the field - other than the occasional clean its worked without any problems, bar the early death of the Proxxon tool!

I'm based in the Lake District if I can be of help to anyone, in advance of me asking the same!

Cheers,
Paul.