VFD HY only rotates at 12000rpm

[SaporeCNC]

Hello everyone
Does anyone know how to configure the Chinese VFD HY on mach3?
I have it with the controller csmio ip-m
It is all connected and configured in mach but the mill only rotates at 12000 rpm and can not change it from mach MDI

these are the values entered in the VFD panel

Pd001 - 1
PD002 - 1
PD003 - 400 (default frequency)
PD004 - 400 (nominal frequency)
PD005 - 400 (high-end frequency)
PD008 - 220 (high-end voltage)
PD009 - 15 (middle end voltage)
PD010 - 8 (low voltage voltage)
PD011 - 200 (minimum frequency allowed)
PD014 - 4 (acceleration time)
PD015 - 6 (deceleration time)
PD046 - 9
PD052 - 2
PD070 - 0 (speed control input)
PD072 - 400 (high frequency)
PD141 - 220 (Nominal spindle voltage)
PD142 - 8.6 (Nominal spindle amperage)
PD143 - 2 (Number of poles)
PD144 - 3000

and the diagram shows how the mach3 is connected and configured
but it only rotates at 12000 rpm

thanks for your help
regards