. .
Page 2 of 2 FirstFirst 12
  1. #11
    Hello everyone
    thanks to the help they gave me and was able to configure and apparently it works well,
    when entering a G code, the VFD and the axis respond to the required speed,
    in the week I will make some cuts and see how everything behaves ...

    the changes you make to make it work were the following

    pd011 configured at 150.00 is the minimum recommended in air-cooled axles and goes to 6000 rpm
    pd070 set to 0 and thus works from 0-10v

    thanks again for your time !!!!

    regards
    Last edited by SaporeCNC; 11-07-2018 at 01:11 AM.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. FOR SALE: Elte type spindle 0.55kW 12000rpm 220AC 3-phase
    By Vladimir_MD in forum Items For Sale
    Replies: 3
    Last Post: 16-05-2010, 06:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •