Quote Originally Posted by Ger21 View Post
No, the UC100 is not made in China.
It's made by CNC Drive in Hungary, who stand behind their products and provide support when needed.

They also make UCCNC, an alternative control software that works with it, which is superior to Mach3 (and GRBL).
Thankyou for that info Gerry.

I will look in to that but plodding out £100 and still having the same control card don't see much point investing money in getting this going when I will end up with the same board..

If I can't get a driver then I will upgrade the control system.

If UCCNC is worth a go then what board do I need to look at getting to enable me to run that software.. if it's not Grbl then what firmware is it?