-
12-10-2019 #1
Dear forum.
I have a XSY-AT1 inverter connected to my lathe motor and yesterday it stopped working with the displayed fault of "ERR 1".
To its defense, i was running "thread cutting rpm".
According to the manual this is "Short Circuit/Current overload/Power Module protection".
In the manual there are no instruction how to clear the fault and the red stop button just display STOP/RESET.
I have tried pressing it down for more than 60 sec and also tried other combinations, but no luck.
Everytime I touch the start button, it pops up as ERR 1.
I have disconnected the motor cables from the inverter to rule out motor error, but this had no impact. the error is in the inverter.
Have you guys tried similar and how did you fix it?
Thank you from DK
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
mach3 won't reset
By dougberrow in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 27-05-2019, 11:25 PM -
Mach 3 new licence, now reset not working..
By Fastesteddy in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 13-07-2018, 07:57 PM -
Help needed with Mach 3 - reset external flashing light
By Tom J in forum General ElectronicsReplies: 7Last Post: 26-03-2017, 08:34 PM -
Sieg KX1 & Mach3 won't come out of emergency reset
By lateAtNight in forum Gantry/Router Machines & BuildingReplies: 32Last Post: 19-06-2015, 06:37 PM
Bookmarks