. .
Page 2 of 2 FirstFirst 12
  1. #11
    looking at the circuit diagram I linked to

    this a simplified diagram of the low voltage supplies to the control circuit

    Click image for larger version. 

Name:	XMT2360 low voltage supply circuit.jpg 
Views:	200 
Size:	82.4 KB 
ID:	24675

    R17 is the large resistor on the board

    its value is 15 K (15000 ohms)
    in parallel with a 100K resistor that gives you a total of 13K

    if you get more than 13K then R17 will need replacing
    has R17 changed colour ?

    Click image for larger version. 

Name:	XMT-2360.jpg 
Views:	195 
Size:	260.3 KB 
ID:	24676

    the resistors drops the rectified mains down to 22V at terminal K4 is linked to K3

    with K3 & K4 open circuit I would of expected you to have 200V DC

    if terminal K4 was shorted to earth
    a number of semiconductors will need checking
    starting with Z1 the 22V zenner and the 78L12 regulator IC

    John
    Last edited by john swift; 14-08-2018 at 01:23 PM.

  2. The Following User Says Thank You to john swift For This Useful Post:


  3. #12
    The machine in question is in fact my X3 mill and not the C3 lathe.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 6
    Last Post: 20-12-2018, 03:40 PM
  2. Huanyang VFD and spindle problem
    By BriceO in forum Spindles & Drive Motors
    Replies: 20
    Last Post: 07-08-2018, 08:56 AM
  3. Problem with Spindle not spinning
    By Noplace in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 22-01-2016, 02:40 PM
  4. seig x3 R8 V MT3
    By dazza in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 18-02-2014, 01:14 PM
  5. CNC spindle control VFD problem
    By djc in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 13-09-2009, 09:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •