1. #1
    Hi All,

    I have finally got the above mill running retrofitted a CS labs motion controller with help from another forum user (Chaz). then discovered the servo drive was faulty on the Z axis I have had that repaired but now I get the occasional glitching where the z servo will just start glitching up and down eventually sending the drive unit into a fault. has anyone else experienced this or does anyone know what the problem could be.

    regards

    Ade

  2. #2
    is shield of encoder cable connected at drive connector?
    is it red cap motor?
    what drives are your triac using?

  3. #3
    Chaz's Avatar
    Lives in Ickenham, West London, United Kingdom. Last Activity: 5 Hours Ago Has been a member for 5-6 years. Has a total post count of 1,193. Received thanks 85 times, giving thanks to others 58 times.
    Quote Originally Posted by battwell View Post
    is shield of encoder cable connected at drive connector?
    is it red cap motor?
    what drives are your triac using?
    The original Baldor setup if I remember correctly.

    My Triac also did this on the X axis, but not often, I suspects it was noise but never got it sorted as it was rare to happen.

Similar Threads

  1. Denford Triac Z axis ball screw removal
    By rgvbaz in forum Denford Mills
    Replies: 1
    Last Post: 27-02-2018, 07:50 PM
  2. FOR SALE: Denford Triac PC inc Denford table plus chucks, and Denford CD software etc
    By Piero franchi in forum Items For Sale
    Replies: 8
    Last Post: 14-02-2017, 03:47 PM
  3. FOR SALE: Denford Triac + Denford Orac + other stuff
    By Clive S in forum Items For Sale
    Replies: 6
    Last Post: 06-02-2017, 10:47 PM
  4. Denford Triac - Help
    By mikeadams1985 in forum Denford Mills
    Replies: 1
    Last Post: 12-01-2017, 09:06 AM
  5. FOR SALE: Denford Triac
    By asto in forum Items For Sale
    Replies: 19
    Last Post: 07-02-2016, 07:28 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •