-
19-09-2018 #11
Hi John , have managed to wire in the x,y,z pins corresponding with the pin table in Mach 3 however I’m not to sure where to place the ssr control that you have noted on the above picture ? Where would I find the correct PIN numbers for that ? Thanks in advance
Adam
-
19-09-2018 #12
Hi Adam
I would expect your Mach3 software will have
2 outputs assigned some thing like this -
Attachment 24859
if your using pins 8 & 9 for example
they will need be set up as active low
John
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Production grade CNC router Vs Homebuilt CNC router advice
By SweetAs in forum New Member IntroductionsReplies: 27Last Post: 16-02-2019, 12:06 PM -
1st CNC Router: Overwhelmed - Some advice please?
By wallyblackburn in forum Gantry/Router Machines & BuildingReplies: 11Last Post: 01-10-2017, 10:02 PM -
Denford router - Brushed router too brushless spindle - Help and advice please
By Tom B in forum Brushless Spindles & MotorsReplies: 4Last Post: 16-05-2016, 09:13 AM -
Looking to buy a ~4'x4' CNC router, advice welcomed
By Franco in forum Marketplace DiscussionReplies: 1Last Post: 02-06-2013, 10:05 PM -
Advice on which cnc router
By Xenophya in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 08-10-2012, 11:25 PM
Bookmarks