Page 2 of 2 FirstFirst 12
  1. #11
    Hi John , have managed to wire in the x,y,z pins corresponding with the pin table in Mach 3 however Iím not to sure where to place the ssr control that you have noted on the above picture ? Where would I find the correct PIN numbers for that ? Thanks in advance

    Adam

  2. #12
    Hi Adam

    I would expect your Mach3 software will have
    2 outputs assigned some thing like this -

    Attachment 24859

    if your using pins 8 & 9 for example
    they will need be set up as active low

    Click image for larger version. 

Name:	SSR connections.jpg 
Views:	23 
Size:	327.9 KB 
ID:	24860


    John

Page 2 of 2 FirstFirst 12

Similar Threads

  1. 1st CNC Router: Overwhelmed - Some advice please?
    By wallyblackburn in forum Gantry/Router Machines & Building
    Replies: 11
    Last Post: 01-10-2017, 10:02 PM
  2. NEW MEMBER: Production grade CNC router Vs Homebuilt CNC router advice
    By SweetAs in forum New Member Introductions
    Replies: 21
    Last Post: 25-03-2017, 10:56 AM
  3. Replies: 4
    Last Post: 16-05-2016, 09:13 AM
  4. Looking to buy a ~4'x4' CNC router, advice welcomed
    By Franco in forum Marketplace Discussion
    Replies: 1
    Last Post: 02-06-2013, 10:05 PM
  5. Advice on which cnc router
    By Xenophya in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 08-10-2012, 11:25 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •