. .
Page 2 of 2 FirstFirst 12
  1. #11
    Ok, thanks!

  2. #12
    Hi!

    I’m about to get the remaining parts that I need for the PSU and I would need some input.
    Here is what I got so far.

    Toroidal transformer, 2x36V, 800 VA. I intend to wire the secondary in parallel to get about 48V rectified.
    A cap rated 80V, 27000 uF.

    Looking at a rectifier rated at 600V 35A. I learned that the rectifier values should exceed the actual values.
    My steppers are rated at 5 amps max and there’s 4 of them. Is it a problem choosing a rectifier that exceed the actual Volts to much?

    Do I need a bleed resistor over the cap? If so, any recommendations of the proper value of the resistor?

    Any recommendations regarding fuses? Type, value and so on?
    I don’t know what they are called in English but I have seen like a flip fuse mounted on a din rail beside the PSU.

    Volt readouts?

    Would appreciate some input and input in general here, thanks!
    Last edited by JW1977; 05-03-2019 at 02:39 PM.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. HSS86 and 2HSS86H Closed Loop Drivers
    By zorro in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 28-08-2018, 04:04 PM
  2. Jmc motor driver 2hss86h
    By noyloj in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 02-01-2017, 08:38 PM
  3. Driver led's
    By Duffman in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 16-01-2016, 02:41 PM
  4. Closed loop Step Servo Drive Driver 2HSS86H + 4.5N.M Motor + Encoder
    By george uk in forum Motor Drivers & Controllers
    Replies: 20
    Last Post: 23-06-2014, 08:38 PM
  5. Replies: 1
    Last Post: 16-03-2014, 07:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •