. .
  1. #1
    I had to move my machine which was epic, including removing most of the wiring. During the move I lost part of the power connector for the spindle so I couldn't lock the wiring into the spindle to ensure no movement.

    After much searching I believe I have sourced the correct replacement

    GX20 4 pin female

    The cheap direct from China source
    https://www.aliexpress.com/item/1set...ceBeautifyAB=0

    UK source
    https://www.ebay.co.uk/itm/GX20-Avia...72.m2749.l2649

    EU source
    http://cnc-plus.de/en/CNC-Electronic...3A---40V-.html

    Hopefully someone else will find this information useful
    Last edited by Desertboy; 20-09-2018 at 12:06 PM.
    http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm

    If you didn't buy it from China the company you bought it from did ;)

  2. #2
    I thought they were GX16 which are a bit smaller in diameter. Just check they will fit through the hole in the end cap.
    Building a CNC machine to make a better one since 2010 . . .
    MK1 (1st photo), MK2, MK3, MK4

  3. The Following User Says Thank You to routercnc For This Useful Post:


  4. #3
    Quote Originally Posted by routercnc View Post
    I thought they were GX16 which are a bit smaller in diameter. Just check they will fit through the hole in the end cap.
    We shall see on Monday I guess.
    http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm

    If you didn't buy it from China the company you bought it from did ;)

  5. #4
    Quote Originally Posted by routercnc View Post
    I thought they were GX16 which are a bit smaller in diameter. Just check they will fit through the hole in the end cap.
    I've sorted it out now and the fitting is a GX20, I'll use the GX16 for my limit switches.
    http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm

    If you didn't buy it from China the company you bought it from did ;)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 1
    Last Post: 24-01-2018, 07:24 PM
  2. What power of spindle for cutting 4mm phenolic with 3mm cutter?
    By Nicholas Collier in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 27-03-2017, 07:26 PM
  3. Which circular connector for spindle
    By ROBCNCAU in forum Spindles & Drive Motors
    Replies: 7
    Last Post: 19-06-2016, 09:20 AM
  4. Replies: 5
    Last Post: 29-09-2014, 02:42 PM
  5. Spindle water hose connector
    By cncJim in forum Marketplace Discussion
    Replies: 6
    Last Post: 20-02-2014, 11:22 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •