Page 2 of 2 FirstFirst 12
  1. #11
    UC100?
    Where was that mentioned before? :D
    You think that's too expensive? You're not a Model Engineer are you? :D

  2. #12
    Quote Originally Posted by magicniner View Post
    UC100?
    Where was that mentioned before? :D
    I had no idea it was what it was. Anyhoo, it's a learning gig. Once I'd connected up the two usb thingies (both have to be connected, apparently. One is for the talky bit from laptop to CNC; the other is to provide a particular voltage to the board) then things started to happen.

    Exciting stuff!
    Last edited by SirRustalot; 18-11-2018 at 11:35 PM.

  3. #13
    Quote Originally Posted by SirRustalot View Post
    I had no idea it was what it was.!
    Yup, just pointing out that you can miss out one bit of info and render everyone completely unable to help.
    You can never supply too many (good) photographs and too much component identification information ;-)
    You think that's too expensive? You're not a Model Engineer are you? :D

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •