Thread: Mister control

  1. #1
    I have the commercial misting system that combines air and coolant. But, as is well documented, it is not a good idea to hang around in the foggy environment it inevitably produces.
    Having taken that on board is there any kind of work around? i,e, shrouding the cutter or whatever that can be employed that avoids dumping the kit and starting again.
    Or is vaporising just not on?

  2. #2
    Hi Leadhead
    Boyan Silyavski had a look @ this some time ago, if you can find his thread.
    Regards
    Mike

  3. #3
    There's also these things:

    http://www.fogbuster.com/

    If I ever have a spare minute I will see if it's possible to make a DIY version, surely can't be that difficult. And I think this the link to the other thread?:

    http://www.mycncuk.com/threads/8061-...-Systems/page1
    Last edited by Voicecoil; 08-11-2018 at 09:47 PM.

Similar Threads

  1. Fogless Mister Systems
    By firetrappe in forum Swarf & Chip Management
    Replies: 21
    Last Post: 28-01-2018, 08:05 AM
  2. Control Panel nearly done!
    By m_c in forum General Discussion
    Replies: 16
    Last Post: 17-11-2017, 02:00 PM
  3. Control box
    By Kev2960 in forum Gantry/Router Machines & Building
    Replies: 9
    Last Post: 03-02-2017, 11:14 PM
  4. Motor control
    By D-man in forum General Electronics
    Replies: 14
    Last Post: 14-02-2016, 03:52 PM
  5. servo control vs stepper control
    By Peter. in forum Motor Drivers & Controllers
    Replies: 24
    Last Post: 17-09-2012, 08:36 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •