Feeds and speeds. Some tips for a newbie please!

[Chaz]

Little machine shop can now suck my plums!
Just had a new 2mm flat 4fl endmill delivered.
Out of the box and broken in 3 minutes!

Sent from my F8331 using Tapatalk

What speeds and feed? What material?

4 flute?

[Dave_stoke]

What speeds and feed? What material?

4 flute?

Exactly this

Sent from my F8331 using Tapatalk

[Chaz]

Exactly this

Sent from my F8331 using Tapatalk

I wouldnt be using 4 flute for brass / alu. 3 at most, 2 is better. Did it snap on first engagement or did it cut for a bit?

[Dave_stoke]

I wouldnt be using 4 flute for brass / alu. 3 at most, 2 is better. Did it snap on first engagement or did it cut for a bit?

It got this far but very aggressive. I suppose I should have dragged the feed slider down. But a calculator should be accurate no?

Sent from my F8331 using Tapatalk

[Chaz]

It got this far but very aggressive. I suppose I should have dragged the feed slider down. But a calculator should be accurate no?

Sent from my F8331 using Tapatalk

From the pic, it looks like you plunged directly into the stock or did it do a helix down? If you plunged then that would be an issue, not the best way to engage a cutter into material. When I cut at new speeds I turn the feed down to 10% and then ramp up once I have done the helix down and then started to make the cuts I expect. Sound / vibration / noise is key.

[Dave_stoke]

From the pic, it looks like you plunged directly into the stock or did it do a helix down? If you plunged then that would be an issue, not the best way to engage a cutter into material. When I cut at new speeds I turn the feed down to 10% and then ramp up once I have done the helix down and then started to make the cuts I expect. Sound / vibration / noise is key.

It's actually a helix entry.

Sent from my F8331 using Tapatalk

[Chaz]

It's actually a helix entry.

Sent from my F8331 using Tapatalk

Material looks a bit gummy. Did it clog up the bit? Id say 4 flute is to blame here (IMHO / 2p).