. .

Thread: Thanks guys

  1. #1
    After hijacking Richards thread... Sorry buddy it wasn't my intention.

    I had a lot of input from chas, sapper and someone else who's name has escaped me.

    I done a DIY cable shielding job on my spindle supply line, wrapped in tinfoil then sealed with copper wire strands and taped. The shielding touches the connector plugs both ends and I ran it externally to the gantry runners to further it from other signal cables. I also earthed all main points.

    Just running a program now. I tried the one it really struggled with a simple lego block program but without cutting. What I was testing for is its ability to return to where it was originally zeroed. And at a feed rate of 200mm/min it seemed to manage it with pinpoint accuracy.

    Prior to doing this it always landed +1.95mm off on x axis. And z was always +2.25mm+ when mack geometry registered +0.0025mm on all 3.

    So huge thanks guys. You lot rock... So far lol

    This is what it's running now
    https://m.facebook.com/story.php?sto...&id=1407677767

    Sent from my F8331 using Tapatalk

  2. #2
    I've turned the feed rate right down and it still seems to be doing as it should.

    Happy days :)

    Sent from my F8331 using Tapatalk

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. hello guys
    By Bected in forum General Discussion
    Replies: 0
    Last Post: 11-05-2017, 12:02 PM
  2. NEW MEMBER: Hi guys
    By chrisjames in forum New Member Introductions
    Replies: 1
    Last Post: 03-11-2015, 11:20 AM
  3. Hi Guys help please
    By cockneyrebel in forum General Discussion
    Replies: 5
    Last Post: 08-09-2015, 06:36 PM
  4. NEW MEMBER: Hi guys
    By andrewbond in forum New Member Introductions
    Replies: 1
    Last Post: 03-09-2010, 07:40 PM
  5. NEW MEMBER: Hello to you Guys
    By Ballot in forum New Member Introductions
    Replies: 2
    Last Post: 01-10-2009, 06:42 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •