Thread: Brass Signage

  1. #1
    Wal's Avatar
    Lives in Stockport, United Kingdom. Last Activity: 22 Hours Ago Has been a member for 6-7 years. Has a total post count of 395. Received thanks 42 times, giving thanks to others 19 times.
    Hello all.

    Had a recent commission to make a one-off brass sign with a rather large area that needed gloss black resin... I did the metalwork on the new(ish) gantry router that Clive and I built last summer (with his help I'll be upgrading it to two screws on the long axis in the not too distant). There was a bit of resonance, but nothing that caused any problems. I'm happy to go slow to keep those cutting forces low...



    I used 0000 Grade steel wool to de-burr and 'relax' the sharp machined edges before polishing and cleaning it a few times over.

    Click image for larger version. 

Name:	IMAG2241_BURST002.jpg 
Views:	43 
Size:	197.8 KB 
ID:	25187 Click image for larger version. 

Name:	IMAG2243_BURST002.jpg 
Views:	42 
Size:	179.1 KB 
ID:	25188 Click image for larger version. 

Name:	IMAG2248_BURST002.jpg 
Views:	40 
Size:	154.4 KB 
ID:	25189

    My DIY resin approach is fine for smaller scale stuff, but for this rather large job I took the resin work out of house to a company in Hockley, Birmingham - Capricorn Coating Services - the results are superb. A few pics:

    Click image for larger version. 

Name:	IMAG2265_BURST002.jpg 
Views:	50 
Size:	135.1 KB 
ID:	25190 Click image for larger version. 

Name:	IMAG2266_BURST002.jpg 
Views:	48 
Size:	165.3 KB 
ID:	25191 Click image for larger version. 

Name:	IMAG2267_BURST002.jpg 
Views:	55 
Size:	135.1 KB 
ID:	25192

    Before commencing work I drilled and tapped four shallow M6 holes to the rear of the plate - these will accept 60mm studs that will get epoxied into four holes drilled in the wall. Overkill..? Probably..

    Wal.

  2. #2
    Lovely job Wal!
    Though we expect nothing less of you ;-)

    - Nick
    You think that's too expensive? You're not a Model Engineer are you? :D

  3. The Following User Says Thank You to magicniner For This Useful Post:

    Wal

Similar Threads

  1. Right bit for cutting brass
    By centurian in forum General Discussion
    Replies: 0
    Last Post: 14-07-2018, 04:40 PM
  2. Replies: 0
    Last Post: 27-06-2017, 11:49 PM
  3. Drill bit for brass
    By CNCDev in forum Metalwork Discussion
    Replies: 3
    Last Post: 23-09-2016, 06:44 PM
  4. Cutting Brass
    By KennyL in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 20-12-2014, 06:31 PM
  5. RFQ: I need apx 100 brass tubes being cut down
    By Chance1234 in forum Projects, Jobs & Requests
    Replies: 0
    Last Post: 02-04-2014, 02:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •