1. #1
    Hi folks,

    I want to start a thread re: a machine I have acquired

    It is a 3Axis mill designed to mill Orthotics but was being scrapped (too long a story for here).

    My questions will mainly be Electrical based ...

    So which sub forum to gain most coverage/knowledge??

    Cheers

    Tim
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  2. #2
    Quote Originally Posted by Wobblybootie View Post
    Hi folks,

    I want to start a thread re: a machine I have acquired

    It is a 3Axis mill designed to mill Orthotics but was being scrapped (too long a story for here).

    My questions will mainly be Electrical based ...

    So which sub forum to gain most coverage/knowledge??

    Cheers

    Tim
    Hi and welcome. There is a general area or DIY one like this - http://www.mycncuk.com/forums/253-DIY-Router-Build-Logs - im sure the Mods will help move if its in the wrong area.

  3. The Following User Says Thank You to Chaz For This Useful Post:


  4. #3
    Cheers Chaz, I'll stick it into general and see what transpires.
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  5. #4
    Hi Tim

    Welcome back to the forum again!

    Either the sections from Chaz or look on the main page for the electrical tab. The electrical system you want to ask about might already have its own area in there or there is a general electrical area.
    Building a CNC machine to make a better one since 2010 . . .
    MK1 (1st photo), MK2, MK3, MK4

  6. The Following User Says Thank You to routercnc For This Useful Post:


  7. #5
    Thanks, I may try stuffing it into the Machine discussion section as the damn thing is a bit of a puzzle and a challenge at the same time. I may get more responses re the machine first then the sparky smoky bit ...
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

Similar Threads

  1. hiwin rail hole placement question
    By deisel in forum Linear & Rotary Motion
    Replies: 2
    Last Post: 02-04-2016, 05:42 PM
  2. Gas Strut placement
    By Noplace in forum Linear & Rotary Motion
    Replies: 2
    Last Post: 17-11-2015, 09:25 PM
  3. Thread diameter
    By Daniel in forum General Discussion
    Replies: 7
    Last Post: 23-02-2012, 06:18 PM
  4. Looking for industrial placement in Computer Aided Design
    By disan in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 10-06-2011, 01:12 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •