Thread: Machinery shops in London
End of november, i being in London. There i will also visit some tools and machinery shops.
For this reason i will ask if somebody can give me tips of interesting (cheap professional) machinery and tool shops in London
General tools, lathe and milling equipment
Depends whereabouts in London and whether you will have access to a car or not...
MachineMart - they do a range of machine tools at various shops in the Capital
Chronos - not in London, but a short drive or train ride North, an Aladdins cave
TPH - to the east side of London
Thanks fot the tips Irving
I have no car with me, and for this reason i can only go to those places witch i can reach with the metro.
I look in the first place for shops with good prices and offers
How is sunny Belgium, whereabouts are you?
If you are limited to using London Transport (the metro here is known as the 'tube') then MachineMart is about the only place I know of that has a showroom in London (they have three), although not all showrooms have machine tools in stock so a phone call beforehand would be sensible.
There is a good route planner for London at www.tfl.gov.uk, outside of London use www.transport-direct.info
TPH is about 80 minutes from central london and involves two tube trains and a bus.
Chronos is a 40 minute train ride from Central London then a 20min bus ride or a local taxi.
There is a secondhand machine dealer, I think they do tooling, sort of near the southern end of chelsea bridge. heading towards chelsea bridge from the south it's down one of the right turns off Queenstown road.
There is another secondhand machine dealer, specialising in home workshop stuff. They are in Sidcup, I consider that London.
There is a large secondhand machine dealer in Penge or Crystal Palace. I haven't been there for twenty years, so it may have closed down and I can't remember the name of the place;-)
There is a big sheet metal machine place in Sutton, but they have a wharehouse full of machine tools aswell. It might be called Hatfields.
again not sure of address, it's left at gander greenlane and then 2nd right;-)
There is a place in Clapham, it's among the houses. You cross the road at a pub that was on 'Minder' and turn in behind the houses:-) I phoned for directions and that is pretty near what he told me, the pub had been on Minder the night before. How I found it god knows. I know another half a dozen like that, but I would have trouble finding them let alone giving directions.
I don't know of many toolshops as I tend to use buck and hickman or SKS. but I noticed on the buck and ryan website that they have a shop near Tottenham court road.
Last edited by graffian; 29-09-2009 at 06:48 PM.
By dstivens in forum Marketplace DiscussionReplies: 3Last Post: 10-05-2014, 06:53 PM
By Peter. in forum General DiscussionReplies: 4Last Post: 15-10-2012, 12:24 PM
By graffian in forum General DiscussionReplies: 5Last Post: 17-09-2010, 01:23 AM
By leitzscope in forum Milling Machines, Builds & ConversionsReplies: 5Last Post: 09-04-2010, 09:09 PM
NEW MEMBER: machineryBy code r in forum New Member IntroductionsReplies: 1Last Post: 26-12-2009, 12:05 AM