Threaded View
-
24-02-2019 #1
Last Activity: 17-03-2023
Hi everyone,
I'm very new with Siemens controllers and I have a problem with measuring the tools in the ATC. This is Emco PC Mill 155 with PC based WinNc Sinumerik 810D/840D control. I've measured all the tools with touch sensor ( 10 in the turret ) and saved the G54 zero offset to the top of the surface of a foam block.
All seems to be fine, but when tryed to start a simple program
------------------
G54
S2000 T2...10 M6
G0 Z0 F100
M30
------------------
some of the tools were in exact zero position but others are 10 - 15mm higher of the surface. One of them were few mm into the material.
I've measured again .. all of them and the result is the same.
What I'm doing wrong? Do I need to save it someware or to call for a special G command for tool compensation.
Any help is very welcome. ThanksLast edited by Maxiscnc; 24-02-2019 at 01:24 PM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Emco Siemens 840D WinNC Zero offset help!
By Maxiscnc in forum Emco Milling MachinesReplies: 11Last Post: 22-02-2019, 07:01 PM -
Edge Probe + tool length probe on same input
By Noplace in forum General ElectronicsReplies: 1Last Post: 18-06-2016, 11:12 AM -
Tool magazine access and the Siemens CNC Sinumerik controls
By cossiegaz in forum Siemens (Sinumerik)Replies: 6Last Post: 05-11-2015, 10:14 PM -
Relationship between Guide rail length and ballscrew length
By CharlieRam in forum Rails, Guideways & BearingsReplies: 6Last Post: 11-07-2014, 11:37 PM -
When do you accept your eye sights going.???
By JAZZCNC in forum General DiscussionReplies: 25Last Post: 28-02-2014, 05:54 PM
Bookmarks